ARC Booster - Build Verified

Size of Board: 52mm WIDE x 41mm HEIGHT (1590B Box Ok!)
The slashed part are changes needed to build RC.

For AC, use 2 diodes in RV and 1 in FW clipper group.
For RC, use 3 diodes in both RV and FW clipper group.

Transistor in the original unit is 2SC1815 (view from top, left to right = ECB)

GSR - build verified

Size of Board: 55mm WIDE x 33 mm HEIGHT (1590B Okay!)
Use BAT41 for Dfor1 and Drev.
Dfor 2 is Germanium Diode, 1n34.

Tone control is actually B100k.
SF Resistor (Below the switch, beside the 2k2 resistor) are actually 6K2 OHMS.
Use OPA2604 or TLC2262. AD712 is another accident...accidentally cloned from ZDRIVE.

3 pads between the 2N7000 MOSFET are the HARD / SOFT Switch.

Introduction

If you are follower of http://pcb4diyeffects.blog.com/, please update your bookmark to this site now. There are too many complaints that the loading is very slow there.

I will slowly move the content over here but http://pcb4diyeffects.blog.com/ will not be retired. However, i will only update all new contents here.

I bit for your patience while the data is moving over. Till then....keep rocking...